![]() Press and hold the control button while reconnecting power.Press and hold the INITIAL SET button for about 10 seconds whilethe power is on. Keep the reset button pressed for about 2 seconds then release.Press and hold the Reset button on the board whilereconnecting the power.Press the reset button and hold 10 for seconds and thenrelease the button. *For MicroDome Duo, MegaVideo 4K and the new generation models The unit will reset to factory settingsįollow the same steps of Hikvision resetting procedure. After the power cable plugged keep holding the reset button around 6seconds, release the reset button.Wait for the self-diagnostic to run twice.While you’re holding down the button, the LED will go toPOST (power on self test).Press and hold the button for a few seconds.Press and hold the reset button while turning back on thecamera.Press button down again and release to reboot camera.Press and hold the reset button for 10 seconds.When the blue light is faded, resetting is done.Hold the button for five seconds (light will be yellowduring this) when the light turns blue release the button.Press and hold the reset button on the bottom of thecamera for several seconds while thepower is on.When the power indicator changes to green (may take up to 40seconds), the process is complete.Press and hold the reset button until the status indicatorblinks.After one second, the green network LED flashes once and remains lighted.įollow the same procedure for Dahua. Both LEDs on the RJ45 connector are extinguished.Press and hold the reset button for 30 seconds.Press and hold the reset button for 5 seconds. Press and hold the reset button for 15 seconds. Press and hold the reset button until the status LED rapidlyblinks.Press and hold the Reset Button for more than 10 seconds. Wait approximately one minute for the camera to finish thereset process and to reboot.Wait for 5 seconds and release the reset button.Connect to power sourceback to device while holding the default button. Disconnect product form the power source.While holding thebutton, connect the power source back.Press and hold the firmware revert button.Disconnect power source from the camera.E Series: Press and hold the reset button until the blue LED (about 5seconds) underneath the camera lights up.This procedure takes around 20seconds and camera will power up. The red PowerLED light will flash on for 3 second first, turn off for about 15 seconds, flash on for another second and turn off again. After the power cable plugged keep holding the reset button.While continuing to hold the reset button, reconnect the powercable. A Series: Follow the same steps of Hikvision resetting procedure….This procedure will reset everything to thefactory settings (password, username etc)Īdvidia has different resetting methods because of OEMsmultiple manufacturers. Visix: Press the reset button and hold it for 10 seconds.Visix V Series: Press and hold the resetbutton for 2 seconds while the device isin use.3xLogic has two different reset methods for differentseries.
0 Comments
Leave a Reply. |